Using your accessory in wet and dusty conditions
To ensure the water and dust resistance of your accessory, the cover for the Micro USB port must be firmly closed.
Your accessory is water and dust resistant in compliance with the Ingress Protection (IP) ratings IP68, as explained in the table below.
These specific IP ratings mean that your accessory is dust resistant and is protected against the effects of immersion for 30 minutes in fresh (non-saline) water up to 1.5 metres deep.
You can use your accessory:
- in dusty environments, for example, on a windy beach.
- when your fingers are wet.
- in some extreme weather conditions, for example, when it’s snowing or raining.
- in fresh (non-saline) water depths of 1.5 metres or less, for example, in a fresh water lake or river.
- in a chlorinated swimming pool.
Even if your accessory is resistant to dust and water, you should avoid exposing it unnecessarily to environments with excessive dust, sand and mud or to moist environments with extreme high or low temperatures. The water resistance ability of the Micro USB port cannot be guaranteed in all environments or conditions.
Never immerse your accessory in salt water or let the Micro USB port come in contact with salt water. For example, if you’re at the beach, remember to keep your accessory away from the sea water. Also, never expose the accessory to any liquid chemicals. For example, if you’re washing dishes by hand using liquid detergent, avoid bringing your accessory in contact with the detergent. After exposure to non-fresh water, rinse your accessory, especially the cover for the Micro USB port, using fresh water.
Normal wear and tear along with damage to your accessory can reduce its ability to resist dust or moisture. After using the accessory in water, dry off the areas around the cover for the Micro USB port.
The GPS tracking accuracy may be affected by condensation building up between the device and the user’s wrist. To avoid such an impact, regularly check for and clean away any moisture.
If the microphone gets wet, its function may be impacted until the water has completely dried. Please note that the drying time can be up to 3 hours depending on the environment. During this time, you can, however, use other features of the accessory that do not utilise the microphone. All compatible accessories, including chargers and Micro USB cables, are not water and dust resistant on their own.
Your warranty does not cover damage or defects caused by abuse or improper use of your accessory (including use in environments where the relevant IP rating limitations are exceeded). If you have any further questions about the use of your products, refer to our Customer support service for help.
IP (Ingress Protection) rating
Your accessory has an IP rating, which means it has undergone certified tests to measure its resistance levels to both dust and water. The first digit in the two-digit IP rating indicates the level of protection against solid objects, including dust. The second digit indicates how resistant the device is to water.
|IP0X: No special protection||IPX0. No special protection|
|IP1X. Protected against solid objects > 50 mm in diameter||IPX1. Protected against dripping water|
|IP2X. Protected against solid objects > 12.5 mm in diameter||IPX2. Protected against dripping water when tilted up to 15 degrees from normal position|
|IP3X. Protected against solid objects > 2.5 mm in diameter||IPX3. Protected against spraying water|
|IP4X. Protected against solid objects > 1 mm in diameter||IPX4. Protected against splashing water|
|IP5X. Protected against dust; limited ingress (no harmful deposit)||IPX5. Protected against water jet spray for at least 3 minutes|
|IP6X. Dust tight||IPX6. Protected against heavy jet spray for at least 3 minutes|
|IPX7. Protected against the effects of immersion in up to 1 metre of water for 30 minutes|
|IPX8. Protected against the effects of continued immersion in water depths greater than 1 metre. The exact conditions are specified for each device by the manufacturer.|